Replies: 3 comments 7 replies
-
Use Previously it was Note how it has been changed: the variable name no longer has |
Beta Was this translation helpful? Give feedback.
-
Thank you @justinh-rahb . However, this still does not work.
Tried again:
There is no question that Ollama runs on 127.0.0.1:11434 and a local IP 192.168.71.171:11434.
I even tried 172.17.0.1 because this is bound to the docker:
The result is now: Hmm..... |
Beta Was this translation helpful? Give feedback.
-
Thanks @justinh-rahb . I got it. I tried: So, I am not sure why this works. If this helps others:My config is Ollama running on a local IP range 192.168.xxx.xxx. I run via systemd.
I updated from ollama-webui to open-webui using the instructions at: Then I removed the old open-webui attempts installed via
Then I used: Note: I map the docker open-webui 8080 port to 3030 for my internal needs. So, openwebui is available in my network at https://192.168.xx.xxx:3030/. Not everyone may need the -p 3030:8080 mapping. |
Beta Was this translation helpful? Give feedback.
-
I am baffled. I had ollama-webui running fine. I updated to open-webui and no matter what I cannot get the webui to connect to the ollama instance.
I tried searching the drive but cannot find where open-webui stores the config data. No matter what I do, I cannot get webui to accept the URL for the ollama instance. It says SAVE but does not save.
No Matter what, the webui tries to use the default docker URL.
My config is Ollama. Verified Ollama running on all ports: 127.0.0.1 and 192.168.71.117. But the docker instance using --network=local or not, specifying the IP OLLAMA_HOST, etc. none allow connection with open-webui.
I am wondering if there might be something left over after the upgrade. I did a full upgrade removing the old ollama-webui.
Just baffled what else could be going on.
Ollama running on all ports 0.0.0.0:11434--verified.
Run openwebui from docker.
I see the open-webui web interface at (for me 3030 but even on default 8080 same). I login but nothing else takes and the open-webui does not see the Ollama instance. I tried all the suggestions for troubleshooting multiple times.
Beta Was this translation helpful? Give feedback.
All reactions